ENGLISH ESPAÑOLFRANÇAISInstruction ManualManual de InstruccionesManuel d’InstructionsBC3150For Occasional Us e OnlyElectrolux Home Produc ts, Inc.1030
10CUTTING METHODSWARNING: Use minimum speedand do not crowd the line when cutting aroundhard objects (rock, gravel, fence posts, etc.),which can damag
11S WHEN BLADE THRUST OCCURS --Blade Thrust can occur without warning ifthe blade snags, stalls, or binds. This ismore likely to occur in areas where
12CLEAN AIR FILTERA dirty air filter decreases engine perform-ance and increases fuel consumption andharmful emissions. Always clean after every5 hour
13Idle Speed AdjustmentAllow engine to idle. Adjust speed until engineruns without trimmer head, blade or optionalattachment moving or spinning (idle
14TROUBLE CAUSE REMEDYEngine will notstart.1.ON/OFF switch inOFF position.2. Engine flooded.3. Fuel tank empty .4. Spark plug not firing.5. Fuel not r
15LIMITED WARRANTYELECTROLUX HOME PRODUCTS, INC.,warrants to the original purchaser that eachnew Weed Eater® brand gasoline tool or at-tachment is fre
16shall be for a period of two years from the ini-tial date of purchase. WHAT IS COVERED:REPAIR O R REPLACEMENT OF PARTS.Repair or replacement of any
2SAFETY RULESWARNING: When using gardeningappliances, basic safety precautions must al-ways be followed to reduce the risk of fire andserious injury.D
3S Never start or run the engine inside aclosed room or building. Breathing exhaustfumes can kill.S Keep handles free of oil and fuel.S Always use the
4equipped with a spark arresting screen. If youoperate in a locale where such regulations ex-ist, you are legally responsible for maintainingthe opera
54. Insert two screws into the screw holes.5. Secure shoulder strap clamp by tighten-ing screws with a hex wrench.30 inches(76 cm)HARNESSADJUSTMENTFOR
6ASSEMBLY INFORMATION -- WEEDBLADEWEEDBLADENOTE: Remove the trimmer head and plasticshield before attaching the metal shield andinstalling the weed bl
78. Insert a small screwdriver into alignedholes. This will keep the shaft from turn-ing while tightening the blade nut.Screwdriver9. TIghten blade nu
8line and oil at a ratio of 40:1. A 40:1 ratio is ob-tained by mixing 3.2 ounces (95 ml) of oil wit h1gallon (4 liters) of unleaded gasoline. DO NOTUS
9NOTE: If engine dies with the choke leverin the OFF CHOKE position, move thechoke lever to the HALF CHOKE positionand pull the rope until engine runs
Comentarios a estos manuales