Poulan HDR500M Manual de usuario

190388 03.23.04 TRPRINTED IN U.S.A.• Assembly• Operation• Maintenance• Service and Adjustments• Storage• Troubleshooting• Repair PartsOWNER'S

10RUNCHOKEOPERATIONFIG. 143215467FIG. 13CHOKE CONTROLRECOIL STARTER HANDLETILLING HINTSCAUTION: Until you are accustomed to handling your tiller, sta

11OPERATIONtire_2tire_1FIG. 16OUTER VIEW OF TIREADJUST WHEELS FOR CULTIVATING (See Figs. 16 and 17)• Place blocks under right hand side of tille

12MAINTENANCEGENERAL RECOMMENDATIONSThe warranty on this tiller does not cover items that have been subjected to operator abuse or negligence. To re

13MAINTENANCEFIG. 18Disconnect spark plug wire before performing any maintenance (except car bu re tor adjustment) to prevent accidental start ing of

14MAINTENANCEMUFFLERDo not operate tiller without muffl er. Do not tamper with exhaust system. Damaged muffl ers or spark arresters could create a fi re

15tire_3TILLERTO ADJUST HANDLE HEIGHT (See Fig. 22)Select handle height best suited for your tilling conditions. Handle height will be different when

16SERVICE AND ADJUSTMENTSFIG. 26TINE REPLACEMENT (See Figs. 24, 25 and 26)CAUTION: Tines are sharp. Wear gloves or other protection when han

17SERVICE AND ADJUSTMENTSTO REPLACE GROUND DRIVE BELT (See Figs. 27 and 28)• Remove belt guard as described in “TO REMOVE BELT GUARD”.•

18SERVICE AND ADJUSTMENTSFIG. 29THROTTLE CONTROLCLAMPSCREWCASING AND WIREFUEL TANKENGINETO ADJUST THROTTLE CONTROL CABLE (See Fig. 29)The throttle co

19Immediately prepare your tiller for storage at the end of the season or if the unit will not be used for 30 days or more.WARNING: Never store the t

2• Never operate the tiller without proper guards, plates, or other safety protective devices in place.• Keep children and pets away.• D

20 Will not start 1. Out of fuel. 1. Fill fuel

LIMITED WARRANTYThe Manufacturer warrants to the original consumer purchaser that this product as manufactured is free from de-fects in materials and

3MAINTENANCE ... 12-14 SERVICE & ADJUSTMENTS ... 15-18STORAGE ...

4ASSEMBLYYour new tiller has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and p

5ASSEMBLYVIEWED FROM R.H. SIDE OF TILLER• Grasp handle assembly. Hold in “up” position. Be sure handle lock remains in gearcase notch. Slide h

6ASSEMBLYATTACH CLUTCH CABLE (See Fig. 6)• Hook end of clutch cable through hole in control bar bracket if necessary.CONTROL BAR BRACKETCLUTCH CAB

7OPERATIONKNOW YOUR TILLERREAD THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TILLER.Compare the illustrations with your tiller to fa

8OPERATION00155HOW TO USE YOUR TILLERKnow how to operate all controls before adding fuel and oil or attempting to start engine.STOPPING (See Fig. 9)TI

9OPERATION• For cold weather operation you should change oil for easier starting (See oil viscosity chart in the Mainte-nance sec tion of this ma