Poulan 115225426 Manual de usuario descargar pdf (Pagina 15)

15

SERVICE AND ADJUSTMENTS

REPLACING THE LINE

For unit to operate properly, the cutting line

should be replaced when line becomes worn to

less than 3 inches in length from the edge of the

line exit tunnels on each side of the cutting head.

1. Remove and discard worn line before

installing new line.

2. Use only 0.1 15 inch (3 mm) diameter

Poulan PRO brand cut length line.

3. Insert one end of the line through the

positioning tunnel.

4. Continue to feed line through tunnel until

line is centered (leaving equal amounts

on each side). See illustration below.

Positioning

tunnel

5. Insert ends of line one at a time through

the line exit tunnels.

6. Pull the line and make sure the line is ex-

tended fully through the tunnels.

Line exit

tunnel

Line exit

tunnel

7. Correctly installed line will be the same

length on both ends.

REPLACING THE CU TT ING HEAD

1. Align hole in the dust cup with the hole in

the side of the gearbox by rotating the

dust cup.

2. Insert a small screwdriver into aligned

holes. This will keep the shaft from turning

while removing and installing trimmer head.

Screwdriver

3. While holding the screwdriver in position,

remove trimmer head by turning clock-

wise (looking from bottom of unit).

4. Thread replacement trimmer head onto

the shaft by turning counterclockwise.

Tighten until secure.

5. Remove the screwdriver.

CARBURETOR IDLE SPEED

ADJUSTMENT

W ARNING: Keep others away when

making idle speed adjustments. The trimmer

head, blade or any optional attachment will be

spinning during most of this procedure. Wear

your protective equipment and observe all safe-

ty precautions. After making adjustments, the

trimmer head, blade or any optional attachment

must not move/spin at idle speed.

The carburetor has been carefully set at the

factory. Adjustments may be necessary if you

notice any of the following conditions:

S Engine will not idle when the throttle is

released.

S The trimmer head, blade or optional

attachment moves/spins at idle.

Make adjustments with the unit supported so

the cutting attachment is off the ground and

will not make contact with any object. Hold

the unit by hand while running and making ad-

justments. Keep all parts of your body away

from the cutting attachment and muf fler.

To adjust idle speed:

Allow engine to idle. Adjust speed until engine

runs without trimmer head, blade or optional

attachment moving or spinning (idle too fast)

or stalling (idle speed too slow).

S Turn idle speed screw clockwise to increase

engine speed if engine stalls or dies.

S Turn idle speed screw counterclockwise to

decrease engine speed if trimmer head,

blade or optional attachment moves or

spins at idle.

WARNING: Recheck the idle speed

after each adjustment. The trimmer head,

blade or optional attachment must not move

or spin at idle speed to avoid serious injury to

the operator or others.

1 2 ... 10 11 12 13 14 15 16 17 18 19

Comentarios a estos manuales

Sin comentarios